Standard Operating Procedure for Precision Surface Grinding Machines
Release time:
2021-12-11
Precision surface grinding machine processing parts with high precision and stable quality. Due to the high positioning accuracy and high repeated positioning accuracy, it is easier to ensure the consistency of part size. As long as the process design and procedures are correct and reasonable, the operation is meticulous, and the parts processing accuracy is high, quality control can be carried out during the processing.
Precision surface grinding machine processing parts with high precision and stable quality. Due to the high positioning accuracy and high repeated positioning accuracy, it is easier to ensure the consistency of part size. As long as the process design and procedures are correct and reasonable, the operation is meticulous, and the parts processing accuracy is high, quality control can be carried out during the processing.
Standard operating procedures for precision surface grinding machines:
1. Before starting work, you must wear protective glasses, buckle your clothes and sleeves, put the long hair plate into the work cap, and wear gloves to operate the grinder.
2. Before operating the precision plane grinding machine, put the tools and workpieces in order to remove the sundries that hinder the operation of the equipment system and the operation activities. Check whether the safety shield of the transmission part is complete and fixed before operation, and deal with any abnormal problems in time.
3. Before starting the precision surface grinder, check whether the transmission part and the operating handle are sensitive, whether the management of each lubricating oil system is unblocked, and whether the electronic ruler displays information data.
4. Before starting the precision surface grinder, adjust the left and right bump limit blocks according to the grinding length of the workpiece, and lock them.
5, the installation of the grinding wheel must be static balance, after correction should be balanced again, the diamond of the grinding wheel dresser must be sharp, its sharp point height should be consistent with the horizontal plane of the center line of the grinding wheel, it is forbidden to use blunt diamond to dress the grinding wheel, dressing, you must start the vacuum cleaner.
6. Start the spindle idling of the precision surface grinder for 1 to 2 minutes, observe the operation, and pay attention to the height of the grinding wheel about 5cm from the table top. Confirm that the lubrication and cooling control system can be unblocked, and then study the grinding operation after each part is running correctly.
7. Check the workpiece, load and unload the grinding wheel, and deal with the failure of the machine tool. Stop the machine after the grinding wheel is withdrawn from the workpiece.
8. For the workpiece adsorbed by the movable disc switch, the firmness of the workpiece after grinding must be checked. For the workpiece with higher or smaller adsorption, the height of the fixed plate should be increased appropriately to prevent the workpiece from loosening and causing potential accidents.
9. When the grinding wheel is close to the workpiece, the workpiece must be touched and removed in a prohibited state. When the grinding wheel does not leave the workpiece, it is not allowed to stop running. Grinding feed should be increased from small to large, not a sudden increase. Uniform cutting is required to prevent the grinding wheel from hitting the workpiece and breaking.
10. After the operation of the precision surface grinder is completed, the vacuum cleaner or water tank should be turned off first, the grinding wheel should be idling for more than 2 minutes, then the power supply of all students should be cut off, the handles should be placed in the non-working position and the power supply should be turned off. Before leaving work, management tools and workpieces should be cleaned and placed neatly, and the table top and surrounding environment should be cleaned well. After one week of continuous work, iron filings in the dust box or water tank should be removed.